[. . . ] Keyhole slot Speaker terminals 4 floor pads Wall Mounting To mount the center speaker horizontally, use the two keyhole slots shown to hang each speaker on two screws that are securely screwed into the wall. Keyhole slots for wall mounting ■ Front STANDBY/ON indicator Red: Subwoofer in standby mode Blue: Subwoofer on With the Auto Standby function, the SKW-770 automatically turns on when an input signal is detected in Standby mode. When there’s no input signal for a while, the SKW-770 automatically enters Standby mode. Attaching the Speaker Bases Before you connect the speakers, attach the supplied speaker base to each SKF-770. [. . . ] POWER ON 7-7/8" (200 mm) Caution: A mounting screw’s ability to support a speaker Wall depends on how well it’s anchored to the wall. If there are no studs, or the walls are solid, use suitable wall anchors. Use screws with a head diameter of 5/16" (8 mm) or less and a shank diameter of 5/32" (4 mm) or 7/32" to 3/8" less. With hollow walls, use a cable/pipe detector to check for any power cables or water (5 to 10mm) pipes before making any holes. Leave a gap of between 7/32" (5 mm) and 3/8" (10 mm) between the wall and the base of the screw head, as shown. ) SKW-770 OFF Using the Cork Stoppers for a More Stable Platform We recommend using the supplied cork stoppers to achieve the best possible sound from your speakers. The cork stoppers prevent the speakers from moving, providing a more stable platform. Cork stoppers Bottom of SKC-770 Caution: A mounting screw’s Wall ability to support a speaker depends on how well it’s anchored to the wall. If you have hollow walls, screw each 7/32" to 3/8" mounting screw into (5 to 10mm) a stud. If there are no studs, or the walls are solid, use suitable wall anchors. Use screws with a head diameter of 5/16" (8 mm) or less and a shank diameter of 5/32" (4 mm) or less. With hollow walls, use a cable/pipe detector to check for any power cables or water pipes before making any holes. Leave a gap of between 7/32" (5 mm) and 3/8" (10 mm) between the wall and the base of the screw head, as shown. ) Setting the Subwoofer Level To set the level of the subwoofer, use the OUTPUT LEVEL control. Set it so that bass sounds are evenly balanced with the treble sounds from the other speakers. Because our ears are less sensitive to very low bass sounds, there’s a temptation to set the level of the subwoofer too high. As a rule of thumb, set the subwoofer level to what you think is the optimal level, and then back it off slightly. Using the Floor Pads for Subwoofer If the subwoofer is placed on a hard floor (wood, vinyl, tile, etc. [. . . ] In general, a good bass sound can be obtained by installing the subwoofer in a front corner, or at one-third the way along the front wall, as shown. 1/3 of wall position Corner position Connecting the Speakers Powered subwoofer Front right speaker Front left speaker Specifications and appearance are subject to change without prior notice. Center speaker Speaker Connection Precautions Red Green White Gray Blue Read the following before connecting your speakers: • Turn off your receiver before making any connections. Connect positive (+) terminals to only positive (+) terminals, and negative (–) terminals to only negative (–) terminals. [. . . ]